Print Page - Can't enable DHCP Server on second interface

Title: Can't enable DHCP Server on second interface
Post by: akaylor on April 10, 2017, 07:15:20 PM

I'm trying to setup a DHCP server on a second LAN interface to segment a lab network. When I go to Services -> DHCP Server the only interface that shows up, of my 3 active, is LAN, though the UI looks like other interfaces should be shown. The DHCP Relay is disabled and both Interface settings look to be the same except for their addresses and name.

Any thoughts as to why I can't add a DHCP server to the second interface? I'm running 2.3.3-RELEASE-p1 on a Protecli 4 port device.

Title: Re: Can't enable DHCP Server on second interface
Post by: bartjsmit on April 10, 2017, 08:39:23 PM

There is no such OPNsense version. Are you sure you are on the right forum?

Bart...

Title: Re: Can't enable DHCP Server on second interface
Post by: franco on April 11, 2017, 06:07:11 AM

This looks like pfSense, and in all fairness, I think that normally the other interfaces don't show up there because their IP address was set to something other than static addressing. You need to assign a static IP. Same with OPNsense.

Cheers,
Franco

Title: Re: Can't enable DHCP Server on second interface
Post by: akaylor on April 12, 2017, 02:23:36 AM

Whops! Yeah, wrong forum. I run OpnSense in my home lab and came here by default. (:

Title: Re: Can't enable DHCP Server on second interface
Post by: franco on April 12, 2017, 08:16:45 AM

Hehe 8)

OPNsense Forum

Archive => 17.1 Legacy Series => Topic started by: akaylor on April 10, 2017, 07:15:20 PM