This is strange to me, so any help troubleshooting is appreciated.
My network consists of my ISP modem, into an opnsense box (latest firmware), which goes out wired via Netgear switches.
I have an AP (Grandstream 7665)connected via POE switch.
My main network is set to 192.168.10.1 and I have VLANs on subnets 20 (IoT), 30(Guest), and 40(Testing).
If I connect via a mobile phone to the main WiFi (10 subnet) the phone will connect immediately but state it has no internet for approximately 20 seconds. I have tested this with multiple devices to rule out the device themselves.
If I connect to any of the VLANs, it will connect immediately and also immediately have internet access.
I've tested variances with the SSIDs, such as WPA2 vs 3, Tri-Band vs 2.4 & 5Ghz, client isolation on/off, etc.
None of the settings impact the connection other than whether I'm connecting to the main 10 subnet. Which makes me think it's an OPNsense setting.
"Not having internet" sounds like a DNS issue to me, but I have the same Unbound DNS rules applied to each interface so I'm not sure why it performs differently.
What am I missing?
Thanks in advance.
Welcome to the forum. Are you able to share the setup of the VLANs and their rules? And do you have Unbound listening to "All interfaces (recommended)"?
Quote from: cookiemonster on March 29, 2025, 12:26:43 AMWelcome to the forum. Are you able to share the setup of the VLANs and their rules? And do you have Unbound listening to "All interfaces (recommended)"?
Thanks for having me.
I was detailing out my answer to you which caused me to see what I overlooked a dozen times.
My LAN had IPv6 set to Track Interface. I set it to None and everything works as intended.
So even though you just asked questions, you helped me greatly. Thank you!
good to hear.