Hi - complete newbie here!
I have configured WireGuard VPN (NordLynx) using multiple guides I found on various forums. VPN works fine, the one issue I have is that Zenarmor does not recognise the interface under devices. Currently all the traffic that is routed over the VPN is displayed as 'Device (none)'.
Is this expected behaviour? I have another WireGuard VPN tunnel configured to enable remote access into the network, this is captured fine in Zenarmor. The only difference I can see is that under VPN > WireGuard > Status this interface has a 'Name', the NordLynx VPN does not.
Any help would be greatly appreciated!
Thanks.
Hi,
Did you protect the Nordlynx interface on Zenarmor? If so, can you see any traffic from this interface in the Reports - Connections - Interfaces & VLAN chart? Lastly, is this interface's IP block assigned to a local usage block?
Interface (wg0) is protected, security zone is set to custom (vpn).
I can see traffic on wg0 under Interfaces & Vlans. If I filter to see live sessions > connections, everything is showing as Device (none) and src hostname is the tunnel IP provided by NordVPN.
Interface IP is in the 10.0.0.0/8 block.
I used this guide to set up the VPN:
https://docs.opnsense.org/manual/how-tos/wireguard-selective-routing.html
Hi,
Are all source hostnames the same? And can you confirm that you can see the devices on other interfaces in Device Identification menu?