Hello all,
I have a WG S2S tunnel up and active, however I cannot ping across the tunnel. I have validated that the allowed IPs are correct on both sides. I feel like I am missing a rule that allows traffic to pass. I try to ping a device on Site B, from my workstation at Site A. I even tried to trace route but didnt get out of my Site A firewall, which is curious. What am I missing?
Thanks,
Steve
Remember that computers blocks access from outside of their own subnet by default.
Is the destination device accessible from another local subnet if any?
Or run packet capture on the LAN of site B to see if packets going out there and if you get responses.