Hello,
I have an opnsense routeur working fine with VLAN and a couple of netgear managed switch.
I just added a tp-link TL-SG105PE poe managed switch that I didn't succeed to configure for VLAN
Here is my setup
Opnsense :
Default LAN (192.168.1.x) +Vlan5 (192.168.5.x)
I use vlan5 for cameras
1st switch netgear:
Connected to opnsense with vlan1 untagged (Lan) + vlan5 tagged. Pvid1
Connected to tp-link with vlan1 (untagged) + vlan5 tagged , pvid1
Connected to camera1, vlan5 untagged pvid5 (works fine)
2nd switch tp-link
Connected to netgear vlan1 untagged, vlan5 tagged, pvid1
Connected to camera2 vlan5 untagged pvid5 (tried also pvid1) static ip on 192.168.5.x
I tried also tagged vlan1 between the 2 switches.
I cannot access camera2 on vlan5 whatever I try.
I don't know if tp-link switch either don't like opnsense or netgear switch or my configuration.
Any ideas?
You're probably going to get chastised for mixing untagged and tagged on the same links, but I don't believe that that's your issue here - at least from the OPNsense perspective.
Since it's working between OPNsense and Netgear, I don't think your issue has anything to do with OPNsense - either the TP-Link switch, or its link to the Netgear, has some issue...