Hello
I have two independent WAN connections, what I would like to do is send one network out on one of the connections and the rest out on the others. Diagram is bellow
Wan ------------ All VLANS
Wan 2 ---------- Video Net only
subnet of the video net 192.168.3.0/24
When I change the outbound NAT from WAN to WAN 2 I can't ping and get no network access, the moment I change it all back it seems to be good.
Looking through the firewall logs it seems like the connections are going out of the WAN ? using the traceroute utility I can't get to 8.8.8.8 from opnsense and if I change the outbound routing all comes good.
The WAN connections are on two ISP's not sharing the same path and are provided by separate providers is there anything else I could try?
I have attached a number of screenshots for reference on the above.
Regards,
Mark
The outbound NAT does only address translation.
To direct traffic out to a non-default gateway you have to add a Policy based routing rule to the Video interface. See: https://docs.opnsense.org/manual/firewall.html#policy-based-routing (https://docs.opnsense.org/manual/firewall.html#policy-based-routing)
Disable (set checkmark) in Firewall: Settings: Advanced "Disable force gateway"
Thanks struggling to find the policy based routing box in the firewall nevertheless will keep looking
Quote from: markjose on December 03, 2024, 09:37:44 PM
Thanks struggling to find the policy based routing box in the firewall nevertheless will keep looking
Thanks this was the answer