OPNsense Forum

Archive => 24.1, 24.4 Legacy Series => Topic started by: Mks on June 16, 2024, 05:55:18 PM

Title: Gateways offline after reboot (re-apply setting brings them back)
Post by: Mks on June 16, 2024, 05:55:18 PM
Hi all,

I face a strange issue since a couple of month.
Now I did a clean installl on new hardware (import of config) but the issue still exists.

After every reboot (and sometimes after a couple of weeks) the gateway goes offline and therefore internet connectivity is lost. All local systems etc. are running without any issue when this issue happens.

Gateway (System: Gateways: Single) is up and running and also within System: Routes: Status the default route is listed.

What I do to solve the issue until the next reboot (or when the issue occurs) is to hit the "Save" (may than the config is re-applied) button within the settings of the gateway (System: Gateways: Single).
Seconds after that internet connectivity is back.

Any idea how to solve or analyze the issue, I found some similar posts from the past but no solution.
Beside that everything works fine.

br
Title: Re: Gateways offline after reboot (re-apply setting brings them back)
Post by: Seimus on June 16, 2024, 05:59:48 PM
Maybe a silly question,

But are your GWs assigned to the correct interface?

Regards,
S.
Title: Re: Gateways offline after reboot (re-apply setting brings them back)
Post by: Mks on June 16, 2024, 07:11:22 PM
Hi,

yes they are.

After pushing the "Save" button (without changing anything) within the settings of the gateway (System: Gateways: Single) it works.

br
Title: Re: Gateways offline after reboot (re-apply setting brings them back)
Post by: BIKTOP on June 16, 2024, 10:20:03 PM
I'm dealing with this issue as well, would appreciate some help!
Title: Re: Gateways offline after reboot (re-apply setting brings them back)
Post by: Mks on June 16, 2024, 10:38:51 PM
Hi,

I already mentioned the issue here https://forum.opnsense.org/index.php?topic=36688 (https://forum.opnsense.org/index.php?topic=36688).

Now I migrated to a new hardware with fresh install and the most recent version of opnsense but the issue still exists, so I started this thread.

Any help, hints, ... highly appreciated.

Thanks