Hello everyone, I encountered a special situation in the new version 24.1. Regarding the System: Gateways: Configuration section, I noticed that once I assign a gateway, it essentially gets stuck there. If I try to delete it, the system won't allow me to perform any actions. After going into edit mode, if I attempt to disable it, I find that it cannot be saved. It wasn't until I activated advanced mode, which required filling in the Weight, that I was able to save. This temporarily resolves the issue of disabling, but as for deleting the gateway, has anyone else encountered the same issue as me?
Thank you.
Do you use multi-wan?
I remember that I probably didn't configure a backup gateway, but what I recall is that when I chose to edit the configured gateway, it kept prompting to enter a weight, which prevented the settings from being saved. Then, after setting the weight, pressing delete had no response.
So, I restored the machine back to version 23.7.12, re-downloaded the IOS, and re-setup the machine, after which this problem did not occur again.