Text only | Text with Images

OPNsense Forum

Archive => 23.7 Legacy Series => Topic started by: OEPro on January 15, 2024, 09:53:05 PM

Title: Fresh install, INTs are correct, unable to ping or access LAN
Post by: OEPro on January 15, 2024, 09:53:05 PM
Hello,
I am new to OPNsense and this forum. I searched but have been unable to find the answer to this./

I performed a new install of 23.7 with no changes to the default configuration. After I assigned the IP address to the LAN interface. I cannot ping; from the unit to the PC plugged into the it (the PC's firewall is off) OR from the PC to the LAN. Of course I cannot access the GUI either.

Because I am so new to this software, I don't know if there is something else that I need to do to enable the LAN/Web GUI, or do I have a defective new Protecil device?

Thank you
Title: Re: Fresh install, INTs are correct, unable to ping or access LAN
Post by: OEPro on January 16, 2024, 12:06:18 AM
No one has seen this?
Title: Re: Fresh install, INTs are correct, unable to ping or access LAN
Post by: cookiemonster on January 16, 2024, 10:32:41 AM
Attach a cable to the unit and see on the console what is happening and what the interfaces assigments are?
Text only | Text with Images