I installed the plugin for FreeRadius and created a client with IP 127.0.0.1 and as Shared Secret I used "password".
I then created some test users with the password "Password"
Finally I created an authentication server using IP and Shared Secret. As a protocol I used PAP.
However, when I try any user in "Tester" I always get the error "The following input errors were detected: Authentication failed."
In "System: Log Files: General" I find "Radius unexpected response"
Where am I wrong?
I just tried this and it works as expected.
Did you create the test users as FreeRadius users (OK) or as System -> Access -> Users (not OK)?
Did you set the type of the authentication server to Radius?
Is the Freeradius Service running?
And more:
All configuration is correct.
Now it works and the only thing I did is restart the firewall.
Compared to your setup, mine has all the standard settings.
- I have not enabled SQLLite
- The Log is on files
- The DHCP Listen IP field is blank
Quote from: meyergru on January 08, 2024, 05:13:25 PM
I just tried this and it works as expected.
Did you create the test users as FreeRadius users (OK) or as System -> Access -> Users (not OK)?
Did you set the type of the authentication server to Radius?
Is the Freeradius Service running?
Now it still doesn't work and I've rechecked everything, screen by screen.
From System - Access - Tester the user is accepted.
From Browser, on VLAN, I have Authentication Failed.
I am demoralized and disappointed.
It's a continuous Doing and Undoing.
Penelope, with her cloth, was an apprentice in comparison.