I have a few cameras around the house that I wanted to block from having internet access so I created a simple rule:
1) Alias listing IP's of the cameras
2) LAN Firewall Rule that blocks the alias list.
I tested this by sticking my iphone's ip address on it and yes it cannot access the internet.
I enabled firewall logs on the block rule and I see that traffic is being blocked per IP
BUT somehow when i get my iphone off of my local wifi and onto cellular and launch the Wyze app, somehow I am still getting the camera feed?
I feel like im taking crazy pills can someone check me? Attached pics of the setup.
Are you sure IPv6 is not used?
Did you purge the state table after adding new rule?
Also are you 100% sure those IPs are being assigned to the cameras?
As mentioned above, do you have enabled IPv6?
Do you have maybe a general permit In rule in the floating rules?
Regards,
S.
Looks like purging the state table did the trick, havent had to do that before - thanks a bunch for the sanity check and advice :)
Yea the state table purge is mandatory. If I remember correctly either on documentation or on forum is mentioned to do that if you implement new rules or reposition rules. This is due to the fact that Rules are checked in order so like per order per index. If you dont purge the table after you moved a rule you may hit a weird behavior.
Also please adjust your thread with [SOLVED], so the forum is a bit clean ;)
Regards,
S.