OpenVPN as Client with ProtonVPN:
Connected but Status "failed"
Can this be a cicada-theme problem?
https://protonvpn.com/support/pfsense-2-6-x-vpn-setup/
I've used Proton for years. it works on opnsense just fine
I get thousands of replay attacks using UDP. so I always used TCP
I didn't say it is not working, but in the interface shows "failed". ProtonVPN TCP das not connect at all here.
check
system > gateways > single.
disabled IP6. and verify its setup to be monitored . or not
Thx, i already tried all that.With monitoring, without, IPv6 Proton gateway disabled, enabled ..
What helped for me, opnsense completely reset, and completely new configuration all of the settings.
Quote from: mkd73 on May 18, 2023, 05:04:30 PM
OpenVPN as Client with ProtonVPN:
Connected but Status "failed"
Can this be a cicada-theme problem?
Nope, I use OpenVPN with ProtonVPN and cicada and it works, and disable IPv6, can you share the client settings ?