Hi after some advice or assistance. We have 2 Wan ports configured on the OpnFSense box. WAN is our primary , priority set to 254, then Starlink set to 255. I have Starlink set as passthrough. And gateway is showing as online. As I had to add this in a very particular manner.
Has anyone managed to get this to work, with failover and ornload balancing. Most importantly getting their Lan to speak out on that network. As I have managed to get to a point where I could get the Gateway to send out traffic, but nothing goes out.
Any assistance would be much appreciated!
Regards
Matt
Have you read the docs?
Sounds like a normal Multi-WAN setup (failover or load balancing)
Hi thanks for the reply, yes I set this up against the Failover Docs without any luck, I think the issue I have is more the Routing of it, as to how does the Lan know where to route traffic to the gateway.
your information is quite vague at best...
if you followed this doc, https://docs.opnsense.org/manual/how-tos/multiwan.html
then you should be good to go... I am not sure however, about your priority...