OPNsense Forum
English Forums => General Discussion => Topic started by: alhaddar on April 07, 2023, 01:18:20 pm
-
Hi
What is the command to install USB to Ethernet Adapter for opnsense
-
If it is supported, it's autodetected, just plug in. If it isn't autodetected, it's not supported.
N.B. USB adapters are generally not recommended.
-
Thank you for your help, but I have a Raspberry and I installed opnsense on it and I only have one network adapter and I have a USB network adapter type AX88179
USB3.0 to 10/100/1000M Gigabit Ethernet, but the problem is that it is slow in speed
Is there a way to use the internal network adapter to be to the two wan and lan
Can I make trunk port
my regards
-
Interfaces > Other Types > VLAN
You will need a VLAN capable switch, of course. And I'd recommend getting a supported Intel/AMD type of device to run OPNsense in production.
-
Thank you for your help