Hi everyone,
I have multiwan setup and wireguard vpn up and running and would like to disable failover for wireguard only.
What I have:
- WAN1 - main connection
- WAN2 - backup connection
- wg0 - outbound vpn for several lan clients
- wg1 - inbound vpn for several remote clients
I think there are some problems with failover recovery with 23.1 but even without those I would rather have vpn bound to WAN1. I am fine with those dropping during WAN1 outage.
I have found https://forum.opnsense.org/index.php?topic=26315.msg127113#msg127113 (https://forum.opnsense.org/index.php?topic=26315.msg127113#msg127113):
QuoteCan you try floating rules, source WAN address, source port wg, Gateway WAN, outbound direction. Same for WAN2. I think the validation was removed some time ago
But I seem to not be able to set any source port when creating Floating rule. Am I missing something? Is this the correct way to set it up or should I try something else?
Thanks in advance.