Hello,
I have two Wireguard "Local" configurations:
- one for clients to connect to my network
- one used as a site-to-site VPN
The second one never works after boot until I go in and disable that "Local" server, then re-enable it. Only after that will the traffic begin flowing again.
Thanks for your time!
Do you also have OpenVPN set up? Is this with wireguard-kmod or wireguard-go?
Cheers,
Franco
Sorry about the late reply, but this problem has been resolved for a while. I'm not sure which Opnsense update fixed it, but it did.
I was experiencing this with both wireguard-kmod and wireguard-go