I'll start off by saying I'm brand new to using OPNsense. I'm building an IPsec tunnel to a remote site and figured out Phase 1 and Phase 2. However, following the documentation it states that I should build an IPsec rule by going to Firewall -> Rules -> IPsec, but this option is not available to me. I just see Floating, LAN, Loopback, and WAN.
I feel like it will probably be obvious, but can someone point me in the right direction to build out the rule?
I figured it out. I needed to uncheck "Install Policy" on the phase 1 configuration. Once I did that, the Rules -> IPsec option appeared.