Print Page - Zenarmor cannot detect OPT1, OPT2 interfaces

Title: Zenarmor cannot detect OPT1, OPT2 interfaces
Post by: albertcuy on February 18, 2022, 12:11:48 PM

Good day!

i've been meaning to try it out, but am running into issues with the setup.

i currently have three interfaces on my test box: LAN, OPT1, OPT2. i was planning to run Zenarmor in transparent mode, with OPT1 and OPT2 as the bridged interfaces.

For some reason the Zenarmor setup cannot see OPT1 and OPT2. Suricata is disabled, both OPT1 & 2 are enabled under Interfaces, and they are not part of any bridge interface.

Any suggestions? Thanks

Title: Re: Zenarmor cannot detect OPT1, OPT2 interfaces
Post by: sy on February 18, 2022, 06:59:01 PM

Hi,

What is the OPT interfaces? Are they Intel?

OPNsense Forum

English Forums => Zenarmor (Sensei) => Topic started by: albertcuy on February 18, 2022, 12:11:48 PM