Text only | Text with Images

OPNsense Forum

English Forums => Zenarmor (Sensei) => Topic started by: dtloken on February 06, 2022, 08:03:40 PM

Title: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
Post by: dtloken on February 06, 2022, 08:03:40 PM
As the topic says, when I enable Zenarmor netmap puts the Mellanox into emulated mode in netmap which then stops passing any traffic, taking my OPNsense box offline on the LAN side. Any ideas on getting this functioning?
Title: Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
Post by: sy on February 07, 2022, 03:54:40 PM
Hi,

Do you have VLAN(s)? If yes are they protected as well?

Title: Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
Post by: dtloken on February 08, 2022, 04:28:49 AM
I have VLANs, but only the physical LAN interface is set to protected.
Title: Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
Post by: sy on February 08, 2022, 02:53:25 PM
Hi,

Please send a bug report from the upper right corner of Zenarmor GUI.
Title: Re: Mellanox ConnectX-3 always goes into emulated mode, doesn’t pass any traffic.
Post by: dtloken on February 09, 2022, 08:48:13 PM
Sent.
Text only | Text with Images