Print Page - DHCPv4 won't start - error with unknown subnet

Title: DHCPv4 won't start - error with unknown subnet
Post by: chemlud on January 30, 2022, 12:33:26 PM

Hi!

I did a fresh install of 22.1 and imported my config from 21.7.7 (after changing interface names in config.xml, to adjust to new hardware). No GUI on interfaces. Reset to factory, switched to Libressl, installed all plugins present in the 21.7 install, imported config.xml and I got a GUI.

But DHCPv4 won't start, complaining:

Code Select

bad range, 10.20.20.2 not in subnet 192.168.169.0 netmask 255.255.224

the 10.20.20.2 is a legit IP in one of the subnets, however, the 192.168.169.0 is on NO interface configured, it's not even mentioned in config.xml.

Any ideas where to start?

Title: Re: DHCPv4 won't start - error with unknown subnet
Post by: chemlud on January 30, 2022, 05:20:30 PM

Re-assigned the interfaces in console, reboot. All good now... ?!?

OPNsense Forum

Archive => 22.1 Legacy Series => Topic started by: chemlud on January 30, 2022, 12:33:26 PM