Hi,
I'm trying to get the routing to 192.168.100.1 (Starlink dish diagnostics page) to work on OPNSense. Initially I only found PFSense guides but I have since found this:
(https://cdn.discordapp.com/attachments/713417473789132812/931954051569045614/unknown.png)
And followed the steps to find it still doesn't work. I'm not sure if it is complicated by having a failover setup, but even disabling the other interface doesn't get this to work.
The only step in the PF Sense Guide (https://www.reddit.com/r/Starlink/comments/m1kny7/guide_starlink_pfsense_guide_for_idiots_no) I couldn't find an OPNSense equivalent for was:
"enable the Disable DNS Forwarder checkbox ("Do not use the DNS Forwarder/DNS Resolver as a DNS server for the firewall"). This removes 127.0.0.1 from the DNS table, which seems to really bork dns lookups via Starlink. "
Any ideas what could be missing?
System: Settings: General: "Do not use the local DNS service as a nameserver for this system".
Cheers,
Franco
Unfortunately still no luck getting through to the starlink dish :( Double checked all of the settings as above.
show how you assigned the virtual IP to WAN and the outbound NAT rule ;-)
What does the browser give you when you try accessing 192.168.100.1 ?
I'm in the same boat I'm afraid. I can provide screenshots if that helps?
Did you solve it?