Hello
I am brand new to the opnsense platform. I recently installed it and I am running it into a Cisco sg300-10 managed switch. With my new setup anything that is wired into Ethernet will not work with airplay. If I change the device to wifi it works with airily just fine. Any ideas what could be going on?
Thanks
Hi
2 thoughts:
1, wired is on a different subnet and you are not repeating mdns between subnets
-> MDNS repeater must be installed in that case
2, the ports needed for Airplay are blocked by the firewall
-) filtering bridge might be enabled in case you use a bridge interface
-) if wired is on a different subnet then you must allow Airplay ports to be routed
br
Christian
Everything is on the same subnet
How would I go about checking the firewall?
If everything is on the same subnet, the firewall cannot possibly be involved, unless set to bridge mode with a rather unusual topology. Please provide a drawing of your network.