Using Wireguard-go as roadwarrior is suiting my needs well as a single iPhone VPN. Problems arise when I try to add more endpoints because the configurations don't work as I imagined -- basically I thought I just add more endpoints and reuse the original Local Config, Public Key, and Tunnel Address.
In a nutshell, for each additional device, do I reuse the the local config's (Public Key, Tunnel Address) and just add additional endpoints or do I need to create completely new Local Config + Tunnel pairs for each additional device?
Thanks,
Chris
No you only need one local config. You will need to check you are not missing steps when adding additional endpoints or misconfiguring.
Remember to use unique /32s for the other endpoints (within the tunnel /24) and to add them to the local config. You might also need to restart WG after doing so
@Greelan,
Yet again! I highly appreciate your superb insight into solving my humble attempts to fully leverage this wonderful platform.
I try to be concise in my inquiries, but you somehow just know what little bit of information I need to get me over the top, i.e, the "unique /32s".
YOU ARE THE MAN!
Chris