Text only | Text with Images

OPNsense Forum

English Forums => General Discussion => Topic started by: fishingboat on June 01, 2021, 06:58:56 PM

Title: Accessing the webGUI from a WAN interface
Post by: fishingboat on June 01, 2021, 06:58:56 PM
Hello!

I have my OPNsense set up with three WANs with failover configured and a single LAN interface.

I can access the webGUI no problem from the LAN,  but I can't get it to load from a device
over one of my WANs, which is essential to my project.

Under the WEBgui settings, it is configured to listen on all interfaces, on port 443.

I've been messing around with firewall rules following forum posts here and elsewhere but I'm
pretty new at this.

Any help is greatly appreciated :)
Title: Re: Accessing the webGUI from a WAN interface
Post by: errored out on August 13, 2021, 10:02:26 PM
Did you setup your rule for the correct interface?
Text only | Text with Images