Just installed on a Lanner NCA-1510:
https://www.lannerinc.com/products/telecom-datacenter-appliances/vcpe-ucpe-platforms/nca-1510
For some reason the SFP interfaces aren't being detected. Is there something special I need to do to enable? The other 4 onboard NIC's are detected fine. I'm guessing I need to load a driver for the SFP's? I've tried adding if_igb_load="YES" to the tunables.
Forgive me for a noob question, making the move over from pfsense. Pfsesne detected the interfaces by default.
Output from pciconf -lv shows the devices:
none10@pci0:3:0:0: class=0x020000 card=0x0000ffff chip=0x15368086 rev=0x03 hdr=0x00
vendor = 'Intel Corporation'
device = 'I210 Gigabit Fiber Network Connection'
class = network
subclass = ethernet
none11@pci0:4:0:0: class=0x020000 card=0x0000ffff chip=0x15368086 rev=0x03 hdr=0x00
vendor = 'Intel Corporation'
device = 'I210 Gigabit Fiber Network Connection'
class = network
subclass = ethernet
And my 4 onboard NIC's:
ix0@pci0:6:0:0: class=0x020000 card=0x00008086 chip=0x15e48086 rev=0x11 hdr=0x00
vendor = 'Intel Corporation'
device = 'Ethernet Connection X553 1GbE'
class = network
subclass = ethernet
ix1@pci0:6:0:1: class=0x020000 card=0x00008086 chip=0x15e48086 rev=0x11 hdr=0x00
vendor = 'Intel Corporation'
device = 'Ethernet Connection X553 1GbE'
class = network
subclass = ethernet
ix2@pci0:7:0:0: class=0x020000 card=0x00008086 chip=0x15e58086 rev=0x11 hdr=0x00
vendor = 'Intel Corporation'
device = 'Ethernet Connection X553 1GbE'
class = network
subclass = ethernet
ix3@pci0:7:0:1: class=0x020000 card=0x00008086 chip=0x15e58086 rev=0x11 hdr=0x00
vendor = 'Intel Corporation'
device = 'Ethernet Connection X553 1GbE'
class = network
subclass = ethernet
Hi guys,
I have the same with Dell server and Broadcom Adv. Dual 10Gb Ethernet network card that uses sfp. I do not see it with ifconfig or when trying to assign interfaces. Can someone please help here?
I'm trying to understand the problem wondering which SFP module was inserted? The post doesn't say.
Cheers,
Franco