Print Page - solved: WAN Gui Access

Title: solved: WAN Gui Access
Post by: holger on February 11, 2021, 10:32:27 AM

hi, is there anything changed in 21.1 behaviour regarding opening WebGUI access from WAN interface?

we have freshly installed opnsense and

- configured a new webgui port,
- proved listining on "all" interfaces is checked
- added a firewall rule to allow to "this firewall",

the firewall log shows, that everything is "green", so firewall shouldn´t be the problem..

but we cannot connect to the gui via wan port.

Title: Re: WAN Gui Access
Post by: holger on February 12, 2021, 02:59:15 PM

We found an info, that we need to set: "reply-to" to inactive.

this was the key, but i wonder why this setting was not needed on our other installations.

Title: Re: solved: WAN Gui Access
Post by: Fright on February 12, 2021, 04:12:27 PM

Quotebut i wonder why this setting was not needed on our other installations

probably you tested other installation not from IPs in same subnet as OPN WAN IP?

OPNsense Forum

Archive => 21.1 Legacy Series => Topic started by: holger on February 11, 2021, 10:32:27 AM