OPNsense Forum
Archive => 21.1 Legacy Series => Topic started by: spectre on February 06, 2021, 07:47:37 pm
-
We have an opnsense device (old sophos UTM).
port 0 = LAN
port 1 = WAN, Cisco n9k switch 1 (port 10)
port 2 = WAN, Cisco n9k switch 2 (port 10)
Both port's on the N9K are in VPC mode.
Can we configure the ports 1+2 of OPNsense, in a similar way? (1 IP available through both interfaces?)
tnx
-
Hi
I've setup some Linux machines connected to VPC'ed Cisco switch ports.
Standard LACP/aggregation driver (bonding driver) works fine there. So I assume you will make it with FreeBSD link-aggregation driver too.
Detailed setup is: a) hashing methods have to match on both sides, e.g: MAC+IP. ; and b) active LACP mode.
Cheers,
T.
-
Yes, LAGG via LACP will be fine.