Print Page - Command line documentation, how to switch https on and off?

Title: Command line documentation, how to switch https on and off?
Post by: opn_mdrescher on September 22, 2020, 04:47:54 PM

Hi members,

I have an OPNsense 19.1.10_1-amd64 in hand, which is running plain http. I was told, there was "a problem with HTTPS", what ever that means...
However, I can not risk breaking the HTTP/HTTPS interface, so I was looking for a command line option switching https on and of. Is there any documentation about command line administration, where to find?

Or, may be, some one could just tell me, how to switch? Cert & key is in place and known to be good.

Title: Re: Command line documentation, how to switch https on and off?
Post by: fabian on September 23, 2020, 04:57:33 PM

There is no toggle in the config but if you reassign the interfaces, it allows you to revert to HTTP.

OPNsense Forum

English Forums => General Discussion => Topic started by: opn_mdrescher on September 22, 2020, 04:47:54 PM