hello all
I am a newbie at opnesens. I managed to install it on a dell r710.
This is a vanilla installation. No vlans no firewall.
opnsense lan is connected (192.168.1.2) to a dumb switch and i do see the other attached devices
from my pc which is in an other room i can access the opnsense server
my wan is set to ppoe with username and password from eolo (ISP) mtu 1500
the dashboard gives me messages than wan is up and displaying ip addresses from the isp
lan 192.168.1.2
wan 100.119.92.52 (i think this is an ipv6 address) how do i change it?
wan-gw 81.74.xx.xx.
the DNS i tried with 8.8.8.8 and with the DNS server address supplied by the ISP to no avail
I can ping www.yahoo.com and googlw .com with success
Yet i cannot access the internet from other devices
this solution is still in development phase. i still need to purchase the necessary smart switches and more powerlines
what am i missing?
Thank you
no worries solved