Print Page - Trex with OPNsense

Title: Trex with OPNsense
Post by: subham1501 on May 30, 2020, 07:43:46 AM

Hi Everyone,

I am Using Trex Traffic Generator to Push the Traffic on Port_1 and Receive from Port_2, But unfortunately i am unable to receive my traffic which i am send to the port_1.

Firewall Rules:
BOTH ports are allow everything.

Still my traffic is dropped on port_1 it self.

Title: Re: Trex with OPNsense
Post by: mimugmail on May 30, 2020, 09:05:52 AM

Try Floating rule with Accept any any?

Title: Re: Trex with OPNsense
Post by: subham1501 on May 30, 2020, 02:35:55 PM

Thanks, After applying rules in Floating Rules, Ping and Arp is working from Trex Traffic Generator side.
When I am sending the 1GE traffic, same thing is happening all ( IPv4 Packets) getting dropped in port.

Title: Re: Trex with OPNsense
Post by: mimugmail on May 30, 2020, 02:48:34 PM

Is this message from application or where? It's not blocked from pf

Title: Re: Trex with OPNsense
Post by: subham1501 on May 30, 2020, 03:00:05 PM

Okay if it was not blocked from pf then why traffic dropped is happening ??

Check In my snaps of traffic generator TX 3.22 Gb to RX 0.0 Gb

OPNsense Forum

English Forums => General Discussion => Topic started by: subham1501 on May 30, 2020, 07:43:46 AM