Hi , Guys.
I am needing help with LCDProc on Opnsense. I have manually edited LCDd-sdeclcd.conf and lcdproc.conf to suit my needs. The LCD is working but i am not able to display the hard drive data. Please see the attached pictures.
I tried to set disk to "false" in the config file but after the reboot it shows up. If i run "service LCDProc onerestart" it doesn't show the hard drive data as per config. If enabled in the config it still doesn't show the data properly.
Thanks for help stay safe.
แทงบอลสดUFABET
(https://mega2slot365-16.webself.net/)
(https://i.ibb.co/dbWs6sy/20200419-203646.jpg)
สูตรแทงบอลรอง (http://mega1work2-llnjuoa.mystrikingly.com/)
(https://i.ibb.co/T1SRYBZ/IMG-0959.jpg)
Im just stuggeling AT the same point. SG310 and 210
Did you find any solution? Could you Post your config, please?
Im completly new on FreeBSD, come from Debian. I was able to start lcdd by cli with onestart, but wasn't able to get it working while Boot.
On top i didnt understand the menu: i can navigate, but the entrees are confusing and i cant managing thomething. So i need a litte starthelp.