Hi,
my OPNSense runs on an ZBOX ZOTAC CI329.
My network adapters:
$ pciconf -lv re1
re1@pci0:2:0:0: class=0x020000 card=0x012310ec chip=0x816810ec rev=0x0c hdr=0x00
vendor = 'Realtek Semiconductor Co., Ltd.'
device = 'RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller'
class = network
subclass = ethernet
$ pciconf -lv re0
re0@pci0:1:0:0: class=0x020000 card=0x012310ec chip=0x816810ec rev=0x0c hdr=0x00
vendor = 'Realtek Semiconductor Co., Ltd.'
device = 'RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller'
class = network
subclass = ethernet
when I activate Intrusion Detection, it seems, it blocks sometimes network traffic.
I get sometimes no IP from DHCP, communication doesn´t work for some time.
BUT there is no entry in Alerts, so it isn´t blocked by detection service.
In Log there is also no entry.
my settings:
Enabled CHECK
IPS mode CHECK
Promiscous mode on or off
Pattern matcher Hyperscan
Interfaces LAN
when I disable "enabled" it works all fine!
Interface can only be LAN, because WAN is over PPOE
Greets
Byte
OK,
I think it´s VLAN on that adapter. When I connect USB-LAN Adapter without VLAN it seems to work.
Greets
Byte
So you have disabled VLAN Hardware Filtering ?
You find it under. /Interface/ Settings
No, its actually set to "Leave default".
Should I turn it to "Disable VLAN Hardware Filtering" and then it works on my intern LAN device?
Greets
Byte
I would suggest to give it a try to set it to "Disable VLAN Hardware Filtering"
This could solve the dhcp-problems and may help with your other problemes as well.