Hi guys,
Has anyone noticed a bug that dropped Loopback interface config(s) after upgrading from 20.1.3 to 20.1.4?
Not a major issue and was an easy enough to fix it, but it took me a little bit to figure out my loopback interface lost it's IP after the upgrade...
Hi,
yes I have realised something like this. I have actually installed 20.1 and saw that in the interface configuration the IPv4 configuration type is set to None although it was configured as static. If I have a look in the Overview of the interfaces the Loopback interface is configured appropriately although you do not see it any more in the configuration. This I have seen only at loopback interfaces. Is there any known reason for this?
Thx
regards Richard
Hi there,
Was fixed in 20.1.5...
https://github.com/opnsense/changelog/blob/master/doc/20.1/20.1.5#L17
Cheers,
Franco
thx for information.