OPNsense Forum

Archive => 20.1 Legacy Series => Topic started by: bebef on February 08, 2020, 10:30:36 AM

Title: Disable VLAN hardware filtering doesn't work?
Post by: bebef on February 08, 2020, 10:30:36 AM
Hi everyone!

I have set "Disable VLAN Hardware Filtering" in the GUI and checked that it's also set in the config.xml. However, all my interfaces have VLAN_HWCSUM set.

I'm investigating my IPv6 checksum issues (https://forum.opnsense.org/index.php?topic=14138 (https://forum.opnsense.org/index.php?topic=14138)) and are digging a bit deeper. That's where I noticed that the VLAN_HWCSUM isn't disabled after all. I don't know if this might be the root cause of the issue, but I just want to disable it to rule out errors.

Any ideas/comments?

Cheers