Print Page - Locked out of gui, any single user edits i can make to switch back to http pls?

Title: Locked out of gui, any single user edits i can make to switch back to http pls?
Post by: mannp on November 26, 2019, 03:11:30 PM

Wondered if I could edit any config files in single user mode to switch the gui back to http please, so I can get back into the gui.

I don't have ssh access (as until today I didn't figure out how to enable it for a new user :( )

Thanks in advance :)

Title: Re: Locked out of gui, any single user edits i can make to switch back to http pls?
Post by: lfirewall1243 on November 26, 2019, 04:10:58 PM

i never used Single User Mode.

But maybe this one can help you
https://forum.netgate.com/topic/42290/changing-from-https-to-http-locked-myself-out/3

"When you select reset webgui password(or set interface address) via console you have an option to revert gui to http."

Title: Re: Locked out of gui, any single user edits i can make to switch back to http pls?
Post by: fabian on November 26, 2019, 06:21:46 PM

When you change an interface via SSH or console it offers to revert to HTTP. Please note that you may also need a fresh browser which did see HSTS yet.

Title: Re: Locked out of gui, any single user edits i can make to switch back to http pls?
Post by: mannp on November 26, 2019, 09:46:07 PM

Thanks very much both for the replies, I will take a look tomorrow when back at the device.

@fabian what do you mean when you say 'change an interface'? a physical interface of the fw?

OPNsense Forum

English Forums => General Discussion => Topic started by: mannp on November 26, 2019, 03:11:30 PM