Print Page - IP SEC, there is no traffic between the two networks

Title: IP SEC, there is no traffic between the two networks
Post by: litusbdn on October 07, 2019, 02:53:59 PM

Good morning,

I have configured a point-to-point tunnel following this guide: https://docs.opnsense.org/manual/how-tos/ipsec-s2s-route.html

The problem is that the vpn tunnel is successfully established, but I have no data traffic between one site (LAN1 192.168.1.x) and the other (LAN 2 192.168.3.X).

Any idea how I can allow traffic?

All Firewall rules (WAN and IPSEC interfaces) are configured on both sides.

I think it's a route problem, but I can't find the solution.

Thanks

Title: Re: IP SEC, there is no traffic between the two networks
Post by: banym on October 08, 2019, 09:55:13 PM

Hi litusbnd,

can you please provide screenshots from both sides configuration and firewall rules?
If possible could you draw some diagram to show the used networks and IPs aswell?

Without that information it is difficult to help you.

OPNsense Forum

English Forums => General Discussion => Topic started by: litusbdn on October 07, 2019, 02:53:59 PM