Hi all,
I have an issue.
Firewall is running 19.1.4
On my firewall I have 3 interfaces:
VLAN10 (10.220.0.0/16) interface address 10.220.0.9
VLAN32 (10.222.0.0/16) interface address 10.222.8.4
WAN
I have a source address (10.220.2.75) comming from VLAN10, and I need it to be translated to an address on VLAN32 (10.222.10.251 or VLAN32 interface address) and run it throuh an IPSEC tunnel.
I can't get this to work. I have tryed to do both one-to-one and outbound nat.
In picture attached is:
- KACE (10.220.2.75)
- Salling_group (IP address that should be reached through IPSEC tunnel. I have also tryed to have WAN address, but still the same)
- VLAN_32_NAT_INTERFACE (VLAN32 interface address as an alias)
Any surggestions ?
Thanks in advance
Rgds,
Jesper
Have anyone had the same problem and have found a solution???