Print Page - vnstatd

Title: vnstatd
Post by: GDixon on December 23, 2018, 06:27:46 PM

I'm using

OPNsense 19.1.b_492-amd64
FreeBSD 11.2-RELEASE-p4-HBSD
OpenSSL 1.0.2q 20 Nov 2018

Checking the logs i found this

Dec 23 11:35:16   vnstatd[63852]: Traffic rate for "em1" higher than set maximum 1000 Mbit (1->138, r2033 t225), syncing.
Dec 23 11:35:16   vnstatd[63852]: Traffic rate for "em0" higher than set maximum 1000 Mbit (1->138, r259 t2136), syncing.
Dec 23 11:35:16   vnstatd[63852]: Monitoring: em0 (1000 Mbit) em1 (1000 Mbit)
Dec 23 11:35:15   vnstatd[63852]: vnStat daemon 1.15 started. (uid:284 gid:284)

How can I set the proper rate or where? Why is the rate set low at 1000 Mbit?

Title: Re: vnstatd
Post by: mimugmail on December 23, 2018, 08:58:04 PM

Fixed in the config, whats your rate?

Title: Re: vnstatd
Post by: GDixon on December 23, 2018, 09:51:16 PM

Not sure what my rate is or refers to and where in the config? I never set any kind of rates.
Pretty basic setup here.

Title: Re: vnstatd
Post by: mimugmail on December 23, 2018, 11:04:37 PM

I mean the amount of throughput ..

Title: Re: vnstatd
Post by: GDixon on December 24, 2018, 12:35:05 AM

Hmmm I have all 1Gb nics and the switch is also Gb along with all clients.
Is this what your referring to?

OPNsense Forum

English Forums => General Discussion => Topic started by: GDixon on December 23, 2018, 06:27:46 PM