Archive > 15.1 Legacy Series

[SOLVED] Outbound NAT

(1/2) > >>

candrist:
Brand new to OPNsense. Have been using m0n0wall for 10+ years.

I am trying to setup Outbound NAT for single computer on network, but it doesn't seem to work. I have it setup in hybrid mode and then add the rule for my specific ip and tell it to make it a static port.

Can someone tell me what I am doing wrong?

slackadelic:
Hmmm if it's outbound NAT you have the source set to WAN... try changing that to LAN.

slackadelic:
I went back and rechecked what I said, you're right it should work, however I have no true way of testing this right now as I do not utilize custom outbound NAT rules at this time.

candrist:
Thanks for looking.

candrist:
I know this is not a feature that most people use. Is there any way to know if how I am setting this up is correct and this is a config issue or a bug in the software?

Navigation

[0] Message Index

[#] Next page