OPNsense Forum
Archive => 20.7 Legacy Series => Topic started by: spokez on March 29, 2021, 04:45:44 pm
-
Hi,
Setup
OpnSense version OPNsense 20.7.8_4-amd64
WAN interface (igb0) is connected to a LTE modem
In addition there are two OpenVPN interfaces where;
- one has a static Public IP assigned
- one has a dynamic IP assigned
Above provides three wan interfaces where the traffic can be routed through using PBR.
Internal network consist of LAN and a few vlans to separate traffic.
LAN -> should be using WAN
vlan10 -> should be using PBR to the OpenVPN with static public IP
vlan20 -> should be using PBR to the OpenVPN with dynamic IP assigned
Problem
Following the manual to setup PBR it's possible to use PBR based on above requirements.
But all access between the different vlans/LAN is not possible even if I open the FW to allow everything to Pass. It's possible from the OpnSense router ping each vlan/LAN but there are no other traffic between them.
Has someone the same setup that can point me to a guide how to make this to work?
Best regards
Mats