Topics

Has anyone installed OPNSense on a Netgate SG-8860?  If so, do you have any instructions on how to install it?

TIA!

How do I change my system-wide DNS to https://quad9.net. I've changed it in DHCP but where else do I change it?

TIA!

I am getting an error message on Rufus when attempting to write the ISO. I did a checksum and its all good.  The error I get is:

Unsupported image

This image either a non-bootable or it sues a boot or compression method that is not supported by Rufus...

When I use the VGA image .img version and use Rufus to DD the file I don't have the error at all and it works.

Anyone else see this issue?

I'm building OPNsense on a new Protectli FW6C system. It installs fine and I do the initial configuration while disconnected (as I am using my Internet connection). I've plugged a monitor into the HDMI port and used the text setup.

Odd thing is I can't seem to get connected to the Internet or get a LAN IP. I haved tried several times to reset it and made sure it has the proper LAN DHCP scope but I get not Internet IP and no LAN IP. I'm only get APIPA addresses locally. On the monitor of my OPNsense box I see:

em0 link state changed to UP when I plug it in and down when I unplug it but still I get no IP.

I've tried to reset to the defaults and do the setup twice and it doesn't work.

Is there something I'm missing?

Thanks so much!

The download link https://opnsense.org/download/ 
shows a signature but doesn't state what hashing algorithm is used.

It would help if it is had those details.  ;)