OPNsense Forum

Archive => 19.1 Legacy Series => Topic started by: antcilli on February 20, 2019, 08:05:02 pm

Title: 19.1 Health Graph Reset
Post by: antcilli on February 20, 2019, 08:05:02 pm

I noticed in the migration notes for 19.1 it mentions a manual reset of the gateway health graphs may be necessary because of the apinger -> dpinger switch.
Is there a way to just reset the health graphs without resetting all of the other netflow data?
I did upgrade and noticed only the health graphs have stopped updating since the upgrade, so if it's possible avoid losing all of the other historical data, instructions would be greatly appreciated!

Title: Re: 19.1 Health Graph Reset
Post by: franco on February 20, 2019, 08:37:29 pm

On the reporting: settings page when you reset the RRD data that will only reset health graphs.

The list below can delete them one by one.


Cheers,
Franco

Title: Re: 19.1 Health Graph Reset
Post by: antcilli on February 21, 2019, 02:57:15 pm

Wow, didn't realize the 'trash icon' next to each report was to flush that individual report. I saw the trash icon and assumed it was to 'remove' that data from being collected.
I just clicked the trash icon next to the '-quality' reports and the issue is resolved.
Thank you for the help!