1
24.1 Production Series / Can't get port forwarding to work
« Last post by uiterlix on Today at 12:14:12 am »Hi,
I'm trying to setup a fairly standard HTTP port forwarding from the WAN to one of the machines in my local network.
What I did:
- In firewall settings/advanced:
- enable Reflection for port forwards
- enable Reflection for port forwards
- In firewall settings/nat/port forward
- create a port forwarind rule with
- protocol: TCP
- destination: WAN address
- destination port range from HTTP to HTTP
- redirect target IP: tried both and Alias as wel as directly inputting the IP of the target node
- redirect target port: 9000 (in this case portainer)
- log: enabled
- nat reflection: use system default
- filter rule association: rule
Unfortunately the port forward does not seem to work. However when I check the log I do see a blue "rdr" log entry for the connection attempt.
I'm a bit lost on what's wrong here and would be really grateful if someone can point me in the right direction.
I'm trying to setup a fairly standard HTTP port forwarding from the WAN to one of the machines in my local network.
What I did:
- In firewall settings/advanced:
- enable Reflection for port forwards
- enable Reflection for port forwards
- In firewall settings/nat/port forward
- create a port forwarind rule with
- protocol: TCP
- destination: WAN address
- destination port range from HTTP to HTTP
- redirect target IP: tried both and Alias as wel as directly inputting the IP of the target node
- redirect target port: 9000 (in this case portainer)
- log: enabled
- nat reflection: use system default
- filter rule association: rule
Unfortunately the port forward does not seem to work. However when I check the log I do see a blue "rdr" log entry for the connection attempt.
I'm a bit lost on what's wrong here and would be really grateful if someone can point me in the right direction.