OPNsense Forum
Archive => 17.7 Legacy Series => Topic started by: duojet on August 08, 2017, 03:07:02 am
-
I had the same issue with the previous version. I had given up thinking it had frozen at 10%. This time I waited but after almost 40min its at around 50%. It shouldn't take this long. Does anyone know what the issue may be?
I have a J3455m motherboard (asrock)
-
It sounds like a driver issue. It could be a bad cable. The installer really only copies the files as fast as the system it runs on lets it.
Cheers,
Franco
-
There is something else wrong. With the same USB drive, same USB port on the PC, and same bios/settings, pfsense installs in about 10 min. Opnsense, after over 2 hours, seemed to be stuck at 75% (although I think it was not stuck, just very slow). I thought it may be related to MBR vs UEFI install (pfsense is MBR), so I tried installing opnsense in MBR mode, but it was equally slow.
What kind of driver issue could it be? Is there something different about freebsd 11 vs 10?
-
Someone noted you could try updating the Bios. If you used pfSense 2.3 you have the difference of FreeBSD 10.3 vs. 11.0 as well as non-UEFI support (SC driver) vs. UEFI-support (VT driver). It's apples and oranges.
Cheers,
Franco