1
General Discussion / how does opnsense block my port scans
« on: August 14, 2022, 12:30:52 am »
So i have opnsense setup, and a plex media server too. Recently I have enabled my plex server to stream remotely rather then just my local home network. IE if I am outside the home, I can still stream my plex media libraries.
With that enabled I thought why don't I do a nmap scan on my public IP and see if I can see the plex port being used 32400. I can not. Even while the stream the going on.
I also have plans to setup the same for my vscode remote dev too.
Here is my testing setup:
1. leave home, go to local coffee shop and use their wifi.
2. ubuntu 20 laptop with nmap
3. connect to my plex via the publicIP:32400. able to stream.
4. nmap my public IP, and nmap reports all ports are down and host is not up. which is freaking awesome.
But i really thought 32400 would be at least up.
these are my cmds that I have tried:
sudo nmap -sP 32400 publicIP/32
sudo nmap -sV -version-intensity 9 publicIP/32
sudo nmap -sPn publicIP/32
With that enabled I thought why don't I do a nmap scan on my public IP and see if I can see the plex port being used 32400. I can not. Even while the stream the going on.
I also have plans to setup the same for my vscode remote dev too.
Here is my testing setup:
1. leave home, go to local coffee shop and use their wifi.
2. ubuntu 20 laptop with nmap
3. connect to my plex via the publicIP:32400. able to stream.
4. nmap my public IP, and nmap reports all ports are down and host is not up. which is freaking awesome.
But i really thought 32400 would be at least up.
these are my cmds that I have tried:
sudo nmap -sP 32400 publicIP/32
sudo nmap -sV -version-intensity 9 publicIP/32
sudo nmap -sPn publicIP/32