1
17.1 Legacy Series / nano image does not reboot un APU3
« on: June 26, 2017, 02:37:39 pm »
Hello !
I received my brand new APU3 [1] a few days ago
I tried to install opnsense on a brand new sd card.
* I downloaded [2]
* uncompressed
* dd if=[2] of=/dev/rdisk2 bs=1m # on my mabookpro
* Put the sd card in the APU
* booted
* configured using the wizard
* reboot
** Kaboom: the /\| wheel is spinning very slowly and ends with a message 'Failed to load kernel' ( some characters doubled, other separated by a blank space...)
I managed to use the "installer" version ( burn a usb flashdrive and installed on the sd card ) : This works OK
Any idea why the gear dos not reboot ?
Thanks in advance
Etienne
[1] https://www.pcengines.ch/apu3b4.htm
[2] OPNsense-17.1.4-OpenSSL-nano-amd64.img.bz2
I received my brand new APU3 [1] a few days ago
I tried to install opnsense on a brand new sd card.
* I downloaded [2]
* uncompressed
* dd if=[2] of=/dev/rdisk2 bs=1m # on my mabookpro
* Put the sd card in the APU
* booted
* configured using the wizard
* reboot
** Kaboom: the /\| wheel is spinning very slowly and ends with a message 'Failed to load kernel' ( some characters doubled, other separated by a blank space...)
I managed to use the "installer" version ( burn a usb flashdrive and installed on the sd card ) : This works OK
Any idea why the gear dos not reboot ?
Thanks in advance
Etienne
[1] https://www.pcengines.ch/apu3b4.htm
[2] OPNsense-17.1.4-OpenSSL-nano-amd64.img.bz2