OPNsense Forum
Archive => 20.7 Legacy Series => Topic started by: loganx1121 on September 22, 2020, 05:05:46 am
-
I have 2 port LAG going from the fw to a cisco switch that has 6 Vlans running over it. All the .1's for the Vlans are on the firewall. I can't seem to get the firewall to advertise any of the Vlan networks over ospf.
I have a L3 LAG running from the firewall to the cisco switch, and that advertises fine. Just wondering what the deal is.
-
Did you check interface and network tabs in OSPF config? Everything fine? Config?
-
Got it to work by setting network type to "Point to multipoint"
-
Actually if you do point to multipoint, you only get a route for the .1 of the vlan that lives on the firewall, so I went with broadcast which adds the entire /24 to the ospf routing table
-
NBMA should be used in usual networks
-
NBMA should be used in usual networks
NBMA for Ethernets? Could you explain?
Thanks,
Patrick
-
No, because it's nonsense, I mixed this .. sorry. :)