1
General Discussion / [SOLVED] How to access LAN from WAN
« on: April 25, 2020, 06:35:03 pm »
Hi all, i have an extremely simple question: How to access LAN from WAN ?
I'm setting up OPNSense firewall; it's freshly installed on a Proxmox server, with 2 RJ45 interfaces bridged.
By default, the FW rule allow my LAN computers to access WAN and internet. Perfect.
I'm setting up my LAN (10.0.0.x) and; for a moment, i need to access my whole LAN from my WAN (all IP and all protocols, ping).
May you explain me how to do ?
Here is my configuration:
Internet<----->[PublicIP]Box[192.168.2.1]<-----WAN(DHCP from Box)----->[192.168.2.134]OPNSense[10.0.0.1])<-----LAN(DHCP from OPNSense)----->Computers, etc...
I've seen example on the forum/net, forum FAQ/Tutorial, and done the following without success:
- "Block private networks" unchecked on the WAN Interface
- Disable NAT (NAT/Outbound set to manual or disable)
- Set up a FW WAN rule (pass-in-Protocol:IPv4*-Source:WAN net-Port:*-Destination:*)
- Set up the gateway of the computer I use to 192.168.2.134 (WAN IP of OPNsense)
Thanks for your help.
I'm setting up OPNSense firewall; it's freshly installed on a Proxmox server, with 2 RJ45 interfaces bridged.
By default, the FW rule allow my LAN computers to access WAN and internet. Perfect.
I'm setting up my LAN (10.0.0.x) and; for a moment, i need to access my whole LAN from my WAN (all IP and all protocols, ping).
May you explain me how to do ?
Here is my configuration:
Internet<----->[PublicIP]Box[192.168.2.1]<-----WAN(DHCP from Box)----->[192.168.2.134]OPNSense[10.0.0.1])<-----LAN(DHCP from OPNSense)----->Computers, etc...
I've seen example on the forum/net, forum FAQ/Tutorial, and done the following without success:
- "Block private networks" unchecked on the WAN Interface
- Disable NAT (NAT/Outbound set to manual or disable)
- Set up a FW WAN rule (pass-in-Protocol:IPv4*-Source:WAN net-Port:*-Destination:*)
- Set up the gateway of the computer I use to 192.168.2.134 (WAN IP of OPNsense)
Thanks for your help.