OPNsense Forum

Archive => 19.1 Legacy Series => Topic started by: DaveRush on May 21, 2019, 09:45:58 pm

Title: Wireguard - multiple endpoints not in wg0.conf
Post by: DaveRush on May 21, 2019, 09:45:58 pm

Hi all, thanks for putting so much hard work into this project, it really shows.

I've got wireguard working on 19.1.8 (prod, but installed via CLI) and noticed that only one endpoint will populate into the wg0.conf -the first one I created. Even if I disable that first-created endpoint, no other will get into the .conf file.

If I manually populate the wg0.conf with the other peer entries it will load the additional config and work fine.

Is there a bug ticket system I should be putting this into, or is it known/fixed already and I just missed it since I'm not on the development build?

Thanks!

Title: Re: Wireguard - multiple endpoints not in wg0.conf
Post by: mimugmail on May 21, 2019, 09:54:55 pm

In local instance you added all endpoints in the multi select field?

Title: Re: Wireguard - multiple endpoints not in wg0.conf
Post by: DaveRush on May 21, 2019, 10:22:01 pm

Aaaand that was it.

Thanks, man, I appreciate it!

Title: Re: Wireguard - multiple endpoints not in wg0.conf
Post by: mimugmail on May 22, 2019, 05:51:22 am

Glad you enjoy it :)

Title: Re: Wireguard - multiple endpoints not in wg0.conf
Post by: loredo on September 01, 2019, 01:17:26 pm

---