OPNsense Forum

Archive => 21.1 Legacy Series => Topic started by: irl on February 04, 2021, 12:12:39 pm

Title: Error in console
Post by: irl on February 04, 2021, 12:12:39 pm

Hi, a made a  fresh install on an Hyper-V.
All works fine but i have always this error message in the console.

xxxxxxxx  OPNsense.localdomain  lighttpd 7851 - - (connections.c.750) invalid request-line -> Sending status 400

An idea ?
Thanks !!!

Title: Re: Error in console
Post by: franco on February 05, 2021, 01:50:44 pm

Something is polling your GUI, maybe some type of automated health script?


Cheers,
Franco

Title: Re: Error in console
Post by: GeoffW on February 23, 2021, 03:15:43 pm

I'm getting the same thing on my VMware VM console.  As far as I can tell the messages come from running the OPNsense GUI, whether it's the dashboard or something else I'm not sure, the messages seem to come a few in a burst and then some delay - sometimes only a few seconds, sometimes many minutes.

If there is any sort of polling of the VM console it must be built into the VMware host, because it's nothing I'm doing.  And the only thing accessing the OPNsense GUI is my browser.

Title: Re: Error in console
Post by: Taomyn on February 23, 2021, 04:35:54 pm

I've seen these appearing for many releases of OPNsense but apart from the annoyance when trying to type when using the console because it always happens just when you don't want it to, I've never thought much else about them. The connections are as stated coming from anything accessing the GUI including the standard browser GUI.